Hi all, I have hathway broadband connection and i today bought a brand new D-Link DIR 605L wireless router. I have never before connected. ![]() Dear Team, I am having two ISp in my office one is Hathway leased line and another is TATA broadband. Recently i have purchased cisco 1941 router.in which i have configured the hathway as a primary isp.after all the configuration users can get the internet through router. I,e from hathway. Now my issue is that,i am having TATA broadband connection,which is configured on Netgear ADSL router with the username and password.dont have static ip for broadband. Now i want to configure this connection on router through ethernet. So that i ahev given the 192.168.2.2 ip to modem and 192.168.2.1 ip to router fast ethernet port. Also give the default route 0.0.0.0 0.0.0.0 192.168.2.2 200 still i amnot getting the internet through tata,if hathway goes down. Hi Rohan, This kind of setup works fine and I've seen it working. The only limitation is that you cannot have any internal machines exposed to Internet via Tata Broadband Anyways coming back to your problem, just by what you described, I can only ask if NAT is enabled on this Ethernet Interface connected to the Netgear ADSL router, because this Netgear device only understands 192.168.2.0/24 subnet. So all your internal traffic needs to be NATed to 192.168.2.1 ip when trying to access internet via Tata Broadband Hope it helps Neeraj. Below is the configuration of router: interface GigabitEthernet0/0 ip address 125.99.113.2 255.255.255.252 ip nat outside ip virtual-reassembly in duplex auto speed auto! Interface GigabitEthernet0/1 ip address 192.168.1.254 255.255.255.0 ip nat inside ip virtual-reassembly in duplex auto speed auto! Interface FastEthernet0/0/0 description connected to tata ISP on netgear DSL modem ip address 192.168.2.1 255.255.255.0 ip nat outside ip virtual-reassembly in duplex auto speed auto! Citizen aqualand ii jp1010 00e manual arts. Interface FastEthernet0/0/1 no ip address shutdown duplex auto speed auto! Ip forward-protocol nd! No ip http server no ip http secure-server! Ip nat inside source list 100 interface GigabitEthernet0/0 overload ip nat inside source static 192.168.1.119 125.99.96.166 ip route 0.0.0.0 0.0.0.0 125.99.113.1 ip route 0.0.0.0 0.0.0.0 192.168.2.2 200! Access-list 100 permit ip 192.168.1.0 0.0.0.255 any! My internal network is 192.168.1.0 /24 with the gateway 192.168.1.254 please assist me on the same. Dear Team, Se we are having hathway with the following wan ip and public ip pool: Wan IP: 125.99.113.2 GW: 125.99.113.1 Public IP pool: 125.99.96.160 to 125.99.96.167 My TATA modem is in PPPOE always on mode.dont have static ip for tata. So my question is that,i want to set hathway line as a primary and TATA as secondary. So if i did the above configuration which is sent by u. Will it affect on existing connection.because i am on remote location.and the router is in Mumbai. So please let me shall i do this configuration. Awaiting your favorable answer.
0 Comments
Leave a Reply. |